
ServicesEntry Doors
Entry Door Replacement in Ponder, TX
We replace worn, drafty or sagging front doors with a complete prehung unit: slab, frame, sill and weatherstripping installed together. Floor protection goes down before the old door comes out, and we tell you exactly when the opening will be open and when it locks again.
What a Proper Entry Door Replacement Involves
Most front door problems are not in the slab. A door that drags, leaks air or won't latch usually has a frame that has racked out of square, a sill that has let water into the subfloor, or weatherstripping that has flattened past the point of sealing. Swapping only the slab leaves those parts in place, so we install prehung units where the door, jambs, hinges and threshold arrive already aligned as one assembly.
We fit fiberglass, steel and wood doors, with or without sidelites and transoms. Fiberglass holds its shape through hot summers and wet springs and won't dent or rust. Steel gives a solid, secure feel at a lower material cost. Wood looks and feels like nothing else but needs finish upkeep on a sun-facing porch. Our team has over 10 years of experience setting all three, and we'll tell you plainly which one suits your entry and how much sun and rain it takes.
What Comes With Your Entry Door Install
A full prehung assembly
The slab, jambs, hinges and threshold come lined up from the factory as a single piece. If moisture ruined your old frame, you can choose jamb bottoms made of composite or rot-resistant material.
Flashed opening with a sill pan
We flash the opening and set a sloped pan beneath the threshold. Any rain that gets under the sill runs back out, keeping the wood framing under your floor dry.
Set square and plumb
Shims go in behind the hinges and the strike, and long screws run from the top hinge into the wall framing. The slab stays up and the gap around it stays even.
Foam and weatherstripping
Low-expansion foam fills the space between jamb and framing without pushing the frame out of shape. Compression weatherstrip and an adjustable threshold finish the seal around the slab.
Locks, casing and trim
Your lockset and deadbolt go on, and we make sure the bolt seats fully in the strike. Inside casing and outside trim are finished, and the perimeter is caulked.
Haul-off and cleanup
The old slab, jambs and debris ride away on our truck. We vacuum the entry, then lift the drop cloths.
Signs Your Front Door Needs Replacing
Light showing past a closed door
Stand inside on a sunny day with the door shut. A sliver of daylight at a corner or along the threshold means the weatherstrip has stopped sealing or the frame has shifted out of square.
Sticking, dragging or a lock that fights you
Expansive clay soil common in this area moves a house slightly between wet and dry seasons, and that can rack a door frame. When the deadbolt only throws if you push or lift the door, the frame and slab no longer line up.
Soft or dark wood at the jamb bottom
Water that pools at a failed sill wicks up into the jamb. Press the lower few inches with a screwdriver; if it gives, the rot has likely reached the sill and subfloor too.
Rust, dents or a cracked skin
A steel door that is rusting at the bottom edge or a wood slab with split panels has lost both its insulation value and much of its strength.
Fogged glass in the lite
A milky haze trapped between the panes of a decorative lite or sidelite tells you the edge seal has broken. Once that happens, the gas fill has leaked out and the glass insulates little better than a single pane.
How Your Door Installation Day Runs
- 1
Measure and choose at home
At your free in-person consultation we measure the rough opening, check the sill and jamb bottoms for rot, and note swing direction. You see material samples and get a written quote with each item listed.
- 2
Order and schedule
Prehung doors are built to your size and options. Once the unit arrives, we call to confirm the date and give you a realistic window for when the opening will be uncovered.
- 3
Protect the entry first
Drop cloths go down inside from the doorway to the work area, and we lay tarps over beds and walkways outside. If pets are home, we talk through how to keep them away from the open doorway.
- 4
Remove, flash and set
We cut the old frame free, inspect the subfloor, install the sill pan and flashing, then set, shim and fasten the new unit, foam the gaps and trim it out.
- 5
Adjust and walk through
We tune the threshold and strike, test the lock with you, show you how to adjust the sill as seasons change, and clean up before we leave.
What Goes Into an Entry Door Price
Your price comes from the door you choose and the state of the opening we uncover. The written quote puts the door, glass, hardware and any framing repair on separate lines, so each charge is easy to trace. To avoid paying everything at once, ask about $0 Down on the whole project; 0% Financing options are offered as well.
- Door material
- Steel tends to be the least expensive, fiberglass sits above it, and stain-grade fiberglass or solid wood costs the most. Your finish and color also move the number.
- Glass, sidelites and transoms
- A decorative lite, full glass, or sidelites on one side or both mean more material and a wider opening to frame and seal.
- Size and configuration
- Standard widths are cheaper than oversized or double doors, and a custom height takes longer to build at the factory.
- Condition of the opening
- If the subfloor or framing below the old sill has rotted, it must be rebuilt so the new door sits level. You see photos of anything we find before extra work is done.
- Hardware
- A standard lockset with deadbolt is the lower-cost choice; a handleset or smart lock costs more, and a multi-point lock more again.
Common Questions About Front Doors
Something not covered here? (940) 308-2581
How long is my entry left without a door?
With one prehung unit, you can normally close and lock the doorway again before the day ends. Added sidelites or framing repair can stretch that, and you hear about it at the consultation so you can plan. We stay until the new door locks.
Is fiberglass or steel the better pick?
Fiberglass shrugs off dents and rust and stays straight through heat and damp, so it suits a doorway that bakes in afternoon sun. Steel is cheaper and feels sturdy, but dents are visible and scratches need paint to keep rust away. We carry samples of each so you can judge side by side.
Could you swap the slab and leave my old frame?
We only put in full prehung units. The drafts and sticking that make people want a new door usually start in the frame and sill, so hanging a fresh slab in a worn frame brings those problems straight back.
Who pays if my entryway gets damaged while you work?
Floors and the walls near the door get covered before anything is torn out, so damage is unlikely. If it happens anyway, we are fully insured and will take you through how it gets fixed.
How is a new front door warrantied?
Labor and product are both backed by a limited lifetime warranty, and a buyer of your home inherits it. We explain the coverage when we give you the quote.
Does a door swap require a permit?
A same-size replacement often goes without one, but it varies by city and by how much work is involved. We find out ahead of install day and take care of the permit if one is required.
See Door Options Without Leaving Home
We bring samples, measure the opening and look at the sill and frame so your quote reflects what's actually there. We also install patio doors, storm doors and replacement windows if you want them on the same visit.